[LIRC] don't work - trust rc-2400

[LIRC] don't work - trust rc-2400 - Printable Version

+- Kodi Community Forum (https://forum.kodi.tv)
+-- Forum: Discussions (https://forum.kodi.tv/forumdisplay.php?fid=222)
+--- Forum: Hardware (https://forum.kodi.tv/forumdisplay.php?fid=112)
+--- Thread: [LIRC] don't work - trust rc-2400 (/showthread.php?tid=103892)

[LIRC] don't work - trust rc-2400 - macer - 2011-06-20

Hi.
Lirc does not work for me Blush

I tried everything. Sad

I am running Trust IR Receiver + Trust RC-2400
It looks like LIRC does not get event from receiver.

Quote:[ 161.573342] usb 3-2: new low speed USB device number 3 using uhci_hcd
[ 161.760708] Registered IR keymap rc-rc6-mce
[ 161.760858] input: Media Center Ed. eHome Infrared Remote Transceiver (147a:e017) as /devices/pci0000:00/0000:00:1d.1/usb3/3-2/3-2:1.0/rc/rc1/input8
[ 161.760948] rc1: Media Center Ed. eHome Infrared Remote Transceiver (147a:e017) as /devices/pci0000:00/0000:00:1d.1/usb3/3-2/3-2:1.0/rc/rc1
[ 161.761170] rc rc1: lirc_dev: driver ir-lirc-codec (mceusb) registered at minor = 0
[ 161.761191] mceusb 3-2:1.0: Registered Formosa21 SnowflakeEmulation on usb3:3

Quote:Bus 003 Device 003: ID 147a:e017 Formosa Industrial Computing, Inc. eHome Infrared Receiver

What to do?

- dashford - 2011-06-20

Do you get any response when you run irw in the command line?

- darkscout - 2011-06-20

Have you set lirc up to use devinput? Looks like it should workfine.

- macer - 2011-06-20

dashford Wrote:Do you get any response when you run irw in the command line?

- macer - 2011-06-20

darkscout Wrote:Have you set lirc up to use devinput? Looks like it should workfine.

Quote:#Parameters for daemon
#

LIRC_DEVICE="/dev/input/by-id/usb-Formosa21_SnowflakeEmulation_C0014E23-event-if00"
LIRC_DRIVER="devinput"
LIRC_EXTRAOPS=""
LIRC_CONFIGFILE="/etc/lirc/lircd.conf"

This is my config

Quote:[root@myhost piotrek]# cat /dev/input/by-id/usb-Formosa21_SnowflakeEmulation_C0014E23-event-if00

When I press buttons, nothing happens

- darkscout - 2011-06-20

What about ir-keytable? What does it show?

- macer - 2011-06-20

Quote:[root@myhost piotrek]# ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event4) with:
Driver mceusb, table rc-rc6-mce
Supported protocols: NEC RC-5 RC-6 JVC SONY LIRC
Enabled protocols: RC-6
Repeat delay = 500 ms, repeat period = 125 ms
[root@myhost piotrek]#

that's it

- macer - 2011-06-20

irrecord does not see any events

- macer - 2011-06-21

any help Sad

- darkscout - 2011-06-21

ir-keytable -t

Press buttons.