question about infolabel System.CPUUsage - Printable Version +- Kodi Community Forum (https://forum.kodi.tv) +-- Forum: Development (https://forum.kodi.tv/forumdisplay.php?fid=32) +--- Forum: Skinning (https://forum.kodi.tv/forumdisplay.php?fid=12) +--- Thread: question about infolabel System.CPUUsage (/showthread.php?tid=188119) |
question about infolabel System.CPUUsage - warlion - 2014-03-04 hi all i had a question when you use $INFO[System.CPUUsage] if you had a dual or quad intel cpu will show all the cpu % CPU0,CPU1 etc but that don't work on 6 to up cores so to make all compatible it is possible to use $INFO[System.CPUUsage(used.percent)] i don't see any information on the wiki on the infolabels http://wiki.xbmc.org/?title=InfoLabels I'm using AMD eight core but not sure if this will work on on quad or lower core to show only the total % thanks RE: question about infolabel System.CPUUsage - warlion - 2014-03-19 Or any information about how this trigger RE: question about infolabel System.CPUUsage - ronie - 2014-03-19 i've added some info to the wiki, but i don't quite understand what you're asking :-) Quote:System.CpuUsage RE: question about infolabel System.CPUUsage - warlion - 2014-03-20 Hi ronie thanks to look into that , ok let me explain a little bit more hope this help using System.CpuUsage depending on your CPU it can be different here are two examples (top) as you see in one system (windows using AMD eight core ) show only the total (bottom) openelec using Intel cuad core it show the different CPU`s cores i didnt know about the System.CoreUsage but not mater what i use for id it always show the cpu ej. $INFO[System.CoreUsage(test)] it shows ej.15.69 using windows with AMD eight core i test it with id 0, cpu 0 , 1, 2, etc etc it always show the same thansk RE: question about infolabel System.CPUUsage - ronie - 2014-03-20 i don't think it's a matter of intel vs amd, but it looks like it depends on what os you're using. my intel i7 on linux: and on windows: RE: question about infolabel System.CPUUsage - warlion - 2014-03-20 is there a way to only show the total for both cases linux and windows? like the system.memory use? Available formats: used, used.percent, free, free.percent, total thanks Ronie |