adapter shows no satconf - Printable Version +- Kodi Community Forum (https://forum.kodi.tv) +-- Forum: Support (https://forum.kodi.tv/forumdisplay.php?fid=33) +--- Forum: PVR & Live TV Support (https://forum.kodi.tv/forumdisplay.php?fid=167) +---- Forum: Tvheadend (https://forum.kodi.tv/forumdisplay.php?fid=168) +---- Thread: adapter shows no satconf (/showthread.php?tid=214604) |
adapter shows no satconf - hegg - 2015-01-11 I ran into a problem with TVHeadend. From one day to the other, the adapter shows no satconf and I'm not able to open a tv channel. I already changed the sat cable without any changes. I'm running TVH Version 3.4.28 Under Configuration > DVB Input > Adapter > Multimuxes every mux hat 100% of quality. When I try to watch TV under xbmc(Kodi), I get no input detected. When I look in status/active subscriptions the state says Testing and after that bad. This is from a restart ov TVHeadend services: http://paste.ubuntu.com/9711308/ Also after a restart of the service I can't watch tv channel. This occurs into syslog, when I try to switch to a tv channel by kodi: Code: Jan 11 13:18:38 xbmc tvheadend[1967]: dvb: diseqc setup failed -1 Did someone now how to fix the issue? RE: adapter shows no satconf - Prof Yaffle - 2015-01-11 You don't say what platform you're on, but I'd guess that the 'bad file descriptor' is the clue - dodgy PCI/USB connection, lack of power to the tuner, tuner going onto power-saving and not waking up, etc. You could also try a later build of tvh - while 3.4 is the last official stable release, it's getting pretty old now and a lot has changed. RE: adapter shows no satconf - hegg - 2015-01-11 Ok, no I'm really confused. I switched back to the old SAT cable, which is selfbuild. Due the fact, that I had problems with my Dreambox before (same cable), I though this cable has a defective contact. So I ordered a new cable. Before I post this topic, I got the same issue with the old (selfbuild) cable. So I connected the new cable - same issue. Switched back to the old cable and actually everything works fine?! Plattform is Ubuntu 14.04 Tuner is TBS 6982 dual tuner dvb-s2 (PCIe) which is connected with a 4-Pin power cable. Is there something in the configuration which is not correct? http://fs1.directupload.net/images/150111/posutd9d.png RE: adapter shows no satconf - Prof Yaffle - 2015-01-11 As I understand it, "close device handle when idle" == "don't hang on to this tuner when you're not using it, so let other things have a play". That *might* be relevant, so you can try clearing that unless you need to share the tuner with other applications. When you get the problem, you can also look into /var/log/syslog to see if there's anything there about the DVB device stopping or restarting, and also keep an eye on /dev/dvb/adapter1 to see if that file disappears for some reason. The 'bad file descriptor" suggests that tvheadend can no longer use the tuner because this file (or a related one) is no longer accessible - it looks where it last saw it, fails to find it, and hence the complaint (I suppose it's vaguely possible that it's an OS or disc I/O problem, but that's not really where I'd start looking). You can also switch on debugging in the tvheadend web interface and see if that tells you any more - the up arrows in the bottom right of the interface, followed by the cog/gear/wheel. |