+- Kodi Community Forum (https://forum.kodi.tv)
+-- Forum: Support (https://forum.kodi.tv/forumdisplay.php?fid=33)
+--- Forum: General Support (https://forum.kodi.tv/forumdisplay.php?fid=111)
+---- Forum: Windows (https://forum.kodi.tv/forumdisplay.php?fid=59)
+---- Thread: No Gui (/showthread.php?tid=356081)
No Gui - Han Solo - 2020-07-27
I have installed the 64 bit kodi and when I start Kodi I get the following "Error: Unable to create GUI. Exiting." I tried installing the windows store version and then O get an error while installing.
RE: No Gui - PatK - 2020-07-27
That's a bit disappointing, it could be that the hardware you have is incompatible (usually a graphic engine failure) or some software gremlin. In many cases, installing the latest Visual C++ Redistribution can solve this issue as one of the download archives was missing this item. Suggest to download Kodi 18.6 from link then re-install 18.7 over top. Should that fail we would need a proper debug log as described here. Log file/Advanced (wiki) you will have to follow the steps in section 3. The Debug Mode code to add to the advancedsettings.xml file
RE: No Gui - Klojum - 2020-07-27
(2020-07-27, 16:37)Han Solo Wrote: "Error: Unable to create GUI. Exiting." I
Which graphics card in your Windows machine is supposed to do all the hard work?
RE: No Gui - Han Solo - 2020-07-27
https://paste.kodi.tv/seqepibaye.kodi
RE: No Gui - Klojum - 2020-07-27
Intel® HD Graphics 2000 (Sandy Bridge) ... That should still work, right?
Could you try running LibreELEC from a bootable USB stick and see if Kodi runs?
RE: No Gui - FXB78 - 2020-07-27
Desktop Resolution: 1280x1024 32Bit at 64Hz
64Hz seems an odd refresh rate, this could be the issue.
RE: No Gui - PatK - 2020-07-27
FTL: FATAL: DX:
eviceResources::CreateDeviceResources: unable to create WARP device. Rendering in not possibleI take it that is a laptop with limited memory and gfx functions...? You didn't have debug turned on via the advancedsettings.xml as noted in post #2 Suggest you heed Klojum advice in post #5 and try LibreELEC.
RE: No Gui - Han Solo - 2020-08-03
I'm not sure if I did correctly. I dl the LibreELEC creator set it to Raspberry Pi 2 and 3 and got the 9.2.3 version. After I created the image I rebooted to USB
MAP in boot menu and all I got was blank screen with a blinking (underscore) cursor.