Kodi Community Forum
Reverts back to 480i after a shutdown - Printable Version

+- Kodi Community Forum (https://forum.kodi.tv)
+-- Forum: Discussions (https://forum.kodi.tv/forumdisplay.php?fid=222)
+--- Forum: Off-Topic (https://forum.kodi.tv/forumdisplay.php?fid=113)
+--- Thread: Reverts back to 480i after a shutdown (/showthread.php?tid=54779)



Reverts back to 480i after a shutdown - cloudrev - 2009-07-16

Hey Guys,

I just got a set of monster component cables off eBay and I have enabled xbmc to run at 720p. Now for some reason I always have to enable it every time I start up XMBC.

I am running a soft mod which I did via the hot swap. I use unleash x as my dash. That never goes to 720p, even though I enable it. I am using Paul's Mediastream Lite v2 and the way I enable 720p is, I go to the system settings, enable it in video hardware and I restart xbmc. Sometimes i'll have to enable it in the appearance option.

Is there anyway to get xbmc to remember that I want it set to 720p? anyone ever run into this?


- Clumsy - 2009-07-16

This question is more suited for http://www.xbox-scene.com I guess. XBMC won't write to your eeprom and the xbox bios is where those settings are stored (or in case of a softmod probably in the bios loaded by the bios loader). Can't help you more, so please check out the xbox-scene.com forums.


- Bigkidoz - 2009-07-17

cloudrev Wrote:Hey Guys,

I just got a set of monster component cables off eBay and I have enabled xbmc to run at 720p. Now for some reason I always have to enable it every time I start up XBMC.

I am running a soft mod which I did via the hot swap. I use unleash x as my dash. That never goes to 720p, even though I enable it. I am using Paul's Mediastream Lite v2 and the way I enable 720p is, I go to the system settings, enable it in video hardware and I restart xbmc. Sometimes i'll have to enable it in the appearance option.

Is there anyway to get xbmc to remember that I want it set to 720p? anyone ever run into this?

I know with my PAL xbox to enable the HD outputs i had to use enigmah to change to NTSC output then add a file called " EEPROM_off.bin" in E\ so that the new settings stayed after reboot and then deleted it.


- joebrady - 2009-07-17

Not too familiar w/ softmods, but if you can still access the default MS xbox dash, you need to change the settings there.


- xttz - 2009-07-27

The softmod's virtual EEPROM needs to be disabled when changing resolution in XBMC, or the settings aren't saved. Depending on your version of ndure, ensure you have EEPROM_off.bin in E:\ (or E:\NKP11\ for version 3.1) while you change the settings, then reboot. If the settings stick after the next startup you can delete the dummy file.