2011-04-30, 04:04
Boy !! I want to throw my toys out of my playpen !!
I fit my new MSI Fusion board into my mini-box case (which looks great !!), I connected the pico PSU to the board.... but uuurgh.. the ATX 4 pin connector cable is too short to get to the CPU connector.
What should I do ?
Should I cut the cable, and then do a hack and join in a short length of cable ?
If I put electrical tape round it, would this suffice ? Or am I going do something wrong.
My technical skills are great, so long as they are limited to putting the round peg in the round hole and the square plug in the square hole,
(I can also remove a toilet cystern to paint behind it properly), but that is it.
??
I fit my new MSI Fusion board into my mini-box case (which looks great !!), I connected the pico PSU to the board.... but uuurgh.. the ATX 4 pin connector cable is too short to get to the CPU connector.
What should I do ?
Should I cut the cable, and then do a hack and join in a short length of cable ?
If I put electrical tape round it, would this suffice ? Or am I going do something wrong.
My technical skills are great, so long as they are limited to putting the round peg in the round hole and the square plug in the square hole,
(I can also remove a toilet cystern to paint behind it properly), but that is it.
??
