2011-05-23, 16:16
Hi,
In general I'm to 99% fine with the 10.1 XBMC Live version running on my ASRock ION330HT (thx for that!).
The ASRock is connected via HDMI to the TV and via S/PDIF to an Denon AVR (5.1 setup).
With an older config (cabling was the same as above) the sound, while navigating to through the XBMC menues, was only sent/played to/by the TV, but not by the AVR.
While the sound of e.g. movies/audio(*) files is only going via the AVR, the "navigation" sound is going to both outputs, these days, which I find a bit annoying.
However I can't figure out the correct sound setting to achieve the same behavior I had before and therefor would appreciate some hints.
(*) PS: another minor thing is that DTS wave files just play as 2.0 on the AVR
In general I'm to 99% fine with the 10.1 XBMC Live version running on my ASRock ION330HT (thx for that!).
The ASRock is connected via HDMI to the TV and via S/PDIF to an Denon AVR (5.1 setup).
With an older config (cabling was the same as above) the sound, while navigating to through the XBMC menues, was only sent/played to/by the TV, but not by the AVR.
While the sound of e.g. movies/audio(*) files is only going via the AVR, the "navigation" sound is going to both outputs, these days, which I find a bit annoying.
However I can't figure out the correct sound setting to achieve the same behavior I had before and therefor would appreciate some hints.
(*) PS: another minor thing is that DTS wave files just play as 2.0 on the AVR