2011-07-23, 22:23
Okay, so i have a big issue with my tvheadend / tvcard. I've been strugling to get everything up and running but its running now or well it was. I add'd my providers main MUX which then add's addtional muxes and ultimately ends up in beeing channels view able from tvheadend/xbmc. Now that worked for like 20 minutes then it lost signal, and now after a reboot or two, i keep getting errors:
"No input detected"
"Too bad signal quality"
Now i've testet the same cable that goes into the pc and that is not the problem, so the problem must lay around the tvcard, i can also see in tvheadend that the signal strenght on the mux's are terrible.
Is there something i'm missing?
I compiled latest V4L driver by following this guide: http://linuxtv.org/wiki/index.php/Techni...leStar_HD2.
Do i need to find some sort of tuner adjustment app? or something?
Running on: Lucid Minimal installation (2.6.32-32-generic) , Technisat Cablestar HD2 , Tvheadend 2.12.99
"No input detected"
"Too bad signal quality"
Now i've testet the same cable that goes into the pc and that is not the problem, so the problem must lay around the tvcard, i can also see in tvheadend that the signal strenght on the mux's are terrible.
Is there something i'm missing?
I compiled latest V4L driver by following this guide: http://linuxtv.org/wiki/index.php/Techni...leStar_HD2.
Do i need to find some sort of tuner adjustment app? or something?
Running on: Lucid Minimal installation (2.6.32-32-generic) , Technisat Cablestar HD2 , Tvheadend 2.12.99
