2011-11-12, 13:20
Hello,
I recently switched from using the mceusb receiver to a Harmony 200 and now I get repeats when pressing a key.
I tried different approaches to solve this, I added to lircd.conf, start lircd with the command line option and added to advanced settings.xml and see that setting loaded in my xbmc log file but all without luck.
The usb receiver is detected as input event interface so when I stop lircd and fire up xbmc the remote still works but then as keyboard, if lircd is running xbmc uses lircd instead of event interface, correct?
However in both cases one key press is seen as 3 or 4 times, with the original remote and the same settings all is well.
Is xbmc using the /dev/event interface and lircd at the same time and if yes how to make sure it only uses lircd?
I recently switched from using the mceusb receiver to a Harmony 200 and now I get repeats when pressing a key.
I tried different approaches to solve this, I added
Code:
suppress_repeat 2
Code:
--repeat-max=0
Code:
<remotedelay>10</remotedelay>
The usb receiver is detected as input event interface so when I stop lircd and fire up xbmc the remote still works but then as keyboard, if lircd is running xbmc uses lircd instead of event interface, correct?
However in both cases one key press is seen as 3 or 4 times, with the original remote and the same settings all is well.
Is xbmc using the /dev/event interface and lircd at the same time and if yes how to make sure it only uses lircd?