2012-03-01, 16:58
I don't know if there is better information on this elsewhere, but FWIW these are the instructions that I use and it works like a champ. (After removing spaces and special characters from my SSID and PW).
http://stmlabs.com/forum/topic/enable-wireless-n/page/4
The post by AIR - though a read through the whole thread proved to be useful. I'm not sure what driver Sam now includes, but I have been using this one instead of the on AIR mentioned:
http://www.broadcom.com/docs/linux_sta/h...112.tar.gz
Again, I have had great success with this method. At least until the feature in the configuration utility is completed.
http://stmlabs.com/forum/topic/enable-wireless-n/page/4
The post by AIR - though a read through the whole thread proved to be useful. I'm not sure what driver Sam now includes, but I have been using this one instead of the on AIR mentioned:
http://www.broadcom.com/docs/linux_sta/h...112.tar.gz
Again, I have had great success with this method. At least until the feature in the configuration utility is completed.