2012-03-25, 13:16
I installed Eden today, first time I try XBMCbuntu. I've always used XBMC on Windows.
Anyhow, the wired network doesn't work.
I've got a Zotac box with the infamous r8169 network module, so naturally first thing I tried was to change it to r8168. I managed to do so, but still no wired network. Wireless workes fine though, I'm on wifi as I'm typing this.
lspci -v
ifconfig
dmesg | grep eth0
Any ideas?
Anyhow, the wired network doesn't work.
I've got a Zotac box with the infamous r8169 network module, so naturally first thing I tried was to change it to r8168. I managed to do so, but still no wired network. Wireless workes fine though, I'm on wifi as I'm typing this.
lspci -v
Code:
01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 03)
Subsystem: ZOTAC International (MCO) Ltd. Device 8168
Physical Slot: 32
Flags: bus master, fast devsel, latency 0, IRQ 43
I/O ports at d800 [size=256]
Memory at fbffb000 (64-bit, prefetchable) [size=4K]
Memory at fbffc000 (64-bit, prefetchable) [size=16K]
Expansion ROM at feae0000 [disabled] [size=128K]
Capabilities: <access denied>
Kernel driver in use: r8168
Kernel modules: r8168
ifconfig
Code:
eth0 Link encap:Ethernet HWaddr XX:XX:XX:XX:XX:XX
inet6 addr: XXXX::XXX:XXXX:XXXX:XXXX/XX Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:198 errors:0 dropped:0 overruns:0 frame:0
TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:32702 (32.7 KB) TX bytes:12378 (12.3 KB)
Interrupt:43
dmesg | grep eth0
Code:
[ 1.661522] eth0: Identified chip type is 'RTL8168D/8111D'.
[ 14.081608] r8168: eth0: link down
[ 14.082127] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 17.175045] r8168: eth0: link up
[ 17.175454] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 18.080025] r8168: eth0: link up
[ 27.800014] eth0: no IPv6 routers present
Any ideas?