Posts: 85
Joined: Jan 2011
Reputation:
0
So I really want to try unraid but am hesitant to spend money building a new system when I have tons of parts laying around.
I have this old Dell dimension 4550 that's not being used. I'll need to upgrade the power supply but with some modifications to the case I could fit 10 drives in there. It's a P4, some where around 3Gz, with 1GB of DDR333. It has zero onboard sata slots but 4 free PCI slots.
Thoughts?
Posts: 458
Joined: Aug 2010
Reputation:
14
Up until recently I was running a my win2003 server on a P4 1.8GHz, 1GB RAM, and an 80GB boot drive. I had a simple PCI bus Promise SATA raid controller (TX4310) running 4 drives in RAID 5 over a gigabit network.
Considering that the PCI bus and the card itself were the throttling points, it did a fairly decent job. On large file transfers I got about 25MB/s read and ~18 MB/s write. Reads and writes were faster to the boot drive, so the PC itself could handle a bit more.
I had no problems serving 1080p content to my Acer Revo R3610. But the server was never stressed with multiple connections.
I don't know what your speed expectations are, but as long as you don't see how fast some of the modern home based NAS devices are, you'll be fine. I saw and I had to upgrade -- very happy as a result.
Ciao.
Posts: 85
Joined: Jan 2011
Reputation:
0
Shouldn't you get 133MBps with PCI? Were you getting 25MBps because there were 4 drives on the PCI bus? If I added 10 drives would it be even slower?
Posts: 458
Joined: Aug 2010
Reputation:
14
Max bandwith is only theoretical. There is always some amount of overhead involved, so you'll never get the full speed. Plus, other devices share the same bus.
The CPU was never working hard, even when transferring data from/to the array. The limitation was the combination of the controller card and the bus. Possibly moreso the controller card, but I never investigated that. The drives were only running in SATA1, but even at that speed it would be enough to saturate the bus.
Those same drives are in my new NAS, and I'm easily getting double the speed under the same circumstances.
The number of drives had nothing to do with the speed. Like I said, reading and writing from the boot drive, connected to onboard IDE, was much faster than from the array in the same PC -- just stuck off an addon controller.
Now, UNRAID isn't conventional raid, so it may behave differently when it comes to speed. I've never played with it, and I'm in no position to comment on anything about it. I'm sure the internet has plenty to say, however.
Ciao.
Posts: 8,569
Joined: Nov 2010
Reputation:
202
eskro
Posting Freak
Posts: 8,569
1. u need to make sure the motherboard takes DDR2.
2. CPU power, get the $40 one
3. good one
Posts: 85
Joined: Jan 2011
Reputation:
0
Alright! I ordered all my parts. I cant wait to build this thing. I hope I didnt make a mistake but I bought one of those inexpensive arrowmax rackmount cases which included a 550W power supply.
David