2012-03-27, 17:57
Been trying for two days to upgrade to Eden and I'm stuck. The installer hangs on a black screen after the splash screen and reacts to nothing. I can't get to other tty's to see what's going on.
My system is the following:
- Zotac Geforce 9300 ITX-Wifi with latest BIOS
- 2GB RAM
- Pentium 2.6Ghz
- 32 GB SSD OCZ Vertex Turbo
The system ran Dharma Live fine.
When I remove quite splash from the start command line, I see the following errors:
Then the screen goes black on both HDMI & VGA, the disc stops spinning, spins up again a bit and then just hangs.
When I try with nomodeset and acpi=off, no go either. It just hangs as well. Ctrl+Alt+F6 does nothing either
I have googled everywhere around but cannot find the solution.
Who can help me to get this up & running? I have no way to look at logs or anything else...
My system is the following:
- Zotac Geforce 9300 ITX-Wifi with latest BIOS
- 2GB RAM
- Pentium 2.6Ghz
- 32 GB SSD OCZ Vertex Turbo
The system ran Dharma Live fine.
When I remove quite splash from the start command line, I see the following errors:
Code:
Begin: Adding live session user ... pwconv failed to change the mode of /etc/passwd- to 0600
* Unable to load LIRC kernel modules. Verify your selected hardware modules in /etc/lirc/hardware.conf
* Starting restore sound card(s') mixer states [fail]
* Loading fallback graphics devices [fail]
Then the screen goes black on both HDMI & VGA, the disc stops spinning, spins up again a bit and then just hangs.
When I try with nomodeset and acpi=off, no go either. It just hangs as well. Ctrl+Alt+F6 does nothing either
I have googled everywhere around but cannot find the solution.
Who can help me to get this up & running? I have no way to look at logs or anything else...