2012-06-10, 18:01
Hi!
I just plugged my Adalight-Setup into my XBMCBuntu-HTPC the first time and am running into some problems.
What I did so far:
Using my mac I installed the image in Adruino IDE and tested my stripes (I have 50 LEDs) with Processing and the ColorSwirl-Programm.. Since that worked nicely I attached everything to said HTPC.
I compiled and installed boblight from their SVN (Revision 400) and created my boblight.conf: http://pastebin.com/H70xSDY0
Then to test this, I rebooted, started boblightd and without running xbmc I started boblight-constant FF0000 from another terminal.
What happens is that when I start boblightd, the LEDs blink red, green, blue and after this nothing happens.
None of the LEDs is on.
I already made sure that /dev/ttyACM0 is the right output-device by watching tail -f /var/log/syslog
Does anybody know what else I can do? ._.
I just plugged my Adalight-Setup into my XBMCBuntu-HTPC the first time and am running into some problems.
What I did so far:
Using my mac I installed the image in Adruino IDE and tested my stripes (I have 50 LEDs) with Processing and the ColorSwirl-Programm.. Since that worked nicely I attached everything to said HTPC.
I compiled and installed boblight from their SVN (Revision 400) and created my boblight.conf: http://pastebin.com/H70xSDY0
Then to test this, I rebooted, started boblightd and without running xbmc I started boblight-constant FF0000 from another terminal.
What happens is that when I start boblightd, the LEDs blink red, green, blue and after this nothing happens.
Code:
(InitLog) start of log /home/sven/.boblight/boblightd.log
(PrintFlags) starting boblightd
(CConfig::LoadConfigFromFile) opening /etc/boblight.conf
(CConfig::CheckConfig) checking config lines
(CConfig::CheckConfig) config lines valid
(CConfig::BuildConfig) building config
(CConfig::BuildConfig) built config successfully
(main) starting devices
(CClientsHandler::Process) opening listening socket on 127.0.0.1:19333
(CDevice::Process) ambilight: starting with output "/dev/ttyACM0"
(CDevice::Process) ambilight: setting up
(CDevice::Process) ambilight: setup succeeded
(CClientsHandler::Process) 127.0.0.1:48428 connected
(CClientsHandler::ParseMessage) 127.0.0.1:48428 said hello
(CClientsHandler::ParseSet) 127.0.0.1:48428 priority set to 128
None of the LEDs is on.
I already made sure that /dev/ttyACM0 is the right output-device by watching tail -f /var/log/syslog
Code:
Jun 10 17:50:39 xbmc kernel: [ 1491.240018] usb 4-3: new full speed USB device number 6 using ohci_hcd
Jun 10 17:50:39 xbmc kernel: [ 1491.473458] cdc_acm 4-3:1.0: ttyACM0: USB ACM device
Does anybody know what else I can do? ._.