2012-10-02, 19:44
Hi -
I have XBMC installed on a HTPC with W7 Ultimate 64 bit. It is connected to an Onkyo AVR 7.1 system with HDMI. I have used this previously with MyMovies and Arcsoft player software with no problems with the audio.
When I use the XBMC interface with the default setup Analoge/2.0 Speakers the audio comes through fine - I can change the Analoge > HDMI audio still comes through fine.
When I select 7.1 speakers - I get no audio. I have tried (I think) every combination of the selections below the first two with no success.
I am new to XBMC and I am sure I doing something very basic incorrectly.
Any help would be appreciated.
My equipment is as follows -
HTPC with ASUS EAH6850 card
Onkyo TX-NR1008 AVR - Audio is handled thru receiver not sent to TV
Mits WD-82838
Ted
I have XBMC installed on a HTPC with W7 Ultimate 64 bit. It is connected to an Onkyo AVR 7.1 system with HDMI. I have used this previously with MyMovies and Arcsoft player software with no problems with the audio.
When I use the XBMC interface with the default setup Analoge/2.0 Speakers the audio comes through fine - I can change the Analoge > HDMI audio still comes through fine.
When I select 7.1 speakers - I get no audio. I have tried (I think) every combination of the selections below the first two with no success.
I am new to XBMC and I am sure I doing something very basic incorrectly.
Any help would be appreciated.
My equipment is as follows -
HTPC with ASUS EAH6850 card
Onkyo TX-NR1008 AVR - Audio is handled thru receiver not sent to TV
Mits WD-82838
Ted