[douggoodwin]

I understand that some people have had success using their Ceton InfiniTV card using NextPVR along with Network Recorder and SageDCT.
I would be grateful if anyone who has made this work would post step by step directions on setting this up. I have been trying to get this right for a while now. Being a noob, I seem to be missing something even after following the directions as closely as possible. I think I'm missing the basic idea of how it's all suppose to work together. SageDCT seems to recognized my card but I can't figure out how to put it all together.

[emveepee]

Currently there is a bug in xbmc's mpeg-ts demux preventing some Ceton files from playing but I am expecting an update of SageDCT from babgvant which will have a work around. Until then, if you have followed the instruction on the wiki http://www.gbpvr.com/nwiki/pmwiki.php?n=...rkRecorder and it doesn't work directly in NextPVR try following these additional steps http://forums.gbpvr.com/showthread.php?5...post452816

Martin

[emveepee]

Correction the updated SageDCT is available http://babgvant.com/blogs/andyvt/archive...2-7-0.aspx for early adopters

Martin

[douggoodwin]

Im all setup and hope to use my atv2 to watch live tv in other rooms. Is there a tutorial on setting up atv2?

[emveepee]

To get XBMC running on the ATV2 check the XBMC wiki, then install the PVR just like other platforms. If you have troubles with 1080i channels, and you might, there is a post about an on the fly transcoding solution on the NextPVR forum.

Martin

[douggoodwin]

Do you have a link to the wiki? I couldn't find it. I enabled the Live Tv on ATV and the NPVR addon. The addon seems to only have 3 important settings: IP, Port,and Pin (not sure what Pin is). I'm thinking that there may be some adjustments needed on my HTPC npvr to complete the set up.

[emveepee]

The wiki was for setting up xbmc you are past that. If you have xbmc running with nextpvr on the host pc, you likely have a firewall problem.

Martin