2013-04-21, 20:21
Hi. I was wondering if it was at all possible to change the way active recording information was fed through to the xbmc clients?
Currently if I am watching an active recording and start it 5 minutes in then the display will show that there is 5 minutes left of the recording and does not change (until you get to 5 minutes in then it just has +8seconds constantly.
Is there any way for the actual time left to be sent to the client? I.e, I start after 5 minutes and it displays 5 minutes left. I then watch 5 minutes (and assuming the recording is still going) it should show 5 minutes left.
If I pause I should see the time left increasing as the recording goes on.
Would be Brill if this is possible
Phil
Currently if I am watching an active recording and start it 5 minutes in then the display will show that there is 5 minutes left of the recording and does not change (until you get to 5 minutes in then it just has +8seconds constantly.
Is there any way for the actual time left to be sent to the client? I.e, I start after 5 minutes and it displays 5 minutes left. I then watch 5 minutes (and assuming the recording is still going) it should show 5 minutes left.
If I pause I should see the time left increasing as the recording goes on.
Would be Brill if this is possible
Phil