Harmony 890 & flirc issue 1 press = multiple presses
#1
I tried searching but with no results that I can't find a answer.

I am using My harmony 890 rf base station to send the signal. 1 button press will most of the time be 2 presses or sometimes 4.

I am wondering if anyone else has run into this issue.

thanks
Reply
#2
What IR codes is the Harmony/basestation sending?
Reply
#3
I am using the flirc xbmc preset from the harmony site.
Reply
#4
If the above solution does not work then...


go to www.myharmony.com

-Change repeats to 2 for Microsoft Media Center or 1....
-Change Inter-Key delay to 300ms for Microsoft Media Center

Sync and try..

if www.myharmony.com does not give you this option (like it didnt give on my Harmony 300)...
contact logitech support and ask them to do it for you...
Reply
#5
thanks will give it a try
Reply
#6
So I figured out some stuff. All my ir emitters from from the RF base was sending signals. I told the harmony only to use the 1 port and tried to hide the ir emitters from them.

so now I don't get 4 presses, but sometime I still get 2. It is weird since it does not happen all the time.
Reply

Logout Mark Read Team Forum Stats Members Help
Harmony 890 & flirc issue 1 press = multiple presses0