2013-09-01, 12:42
Hi all,
I recently installed XBMCBuntu v12.2 on a Zotac Ion motherboard and I'm unable to get wakeup from an IR remote working, largely it seems because I'm unable to add new USB devices to /proc/acpi/wakeup.
I've been following this guide: and have carried out all the steps until 2.1 where it tells me to update /proc/acpi/wakeup based on which USB device my IR receiver is connected to, which in my case is 4-4. So I run:
Which does nothing, running:
returns:
Which is exactly the same as before running the echo "USB4" command. I've tried echoing USB3-5, I've tried sudo su and then running it but nothing actually enters a different USB device. I can enable/disable the ones that are already in the list, but I'm unable to add new ones in.
Any ideas?
Cheers!
I recently installed XBMCBuntu v12.2 on a Zotac Ion motherboard and I'm unable to get wakeup from an IR remote working, largely it seems because I'm unable to add new USB devices to /proc/acpi/wakeup.
I've been following this guide: and have carried out all the steps until 2.1 where it tells me to update /proc/acpi/wakeup based on which USB device my IR receiver is connected to, which in my case is 4-4. So I run:
Code:
sudo sh -c 'echo "USB4" > /proc/acpi/wakeup'
Which does nothing, running:
Code:
cat /proc/acpi/wakeup
returns:
Code:
Device S-state Status Sysfs node
SMB0 S4 *enabled pci:0000:00:03.2
USB0 S4 *enabled pci:0000:00:04.0
USB2 S4 *enabled pci:0000:00:04.1
US15 S4 *enabled pci:0000:00:06.0
US12 S4 *enabled pci:0000:00:06.1
NMAC S5 *enabled pci:0000:00:0a.0
PBB0 S4 *disabled pci:0000:00:09.0
HDAC S4 *disabled pci:0000:00:08.0
XVR0 S4 *disabled pci:0000:00:0c.0
XVR1 S4 *disabled
P0P5 S4 *disabled
P0P6 S4 *disabled pci:0000:00:15.0
P0P7 S4 *disabled pci:0000:00:16.0
P0P8 S4 *disabled pci:0000:00:17.0
P0P9 S4 *disabled pci:0000:00:18.0
PWRB S4 *enabled
Which is exactly the same as before running the echo "USB4" command. I've tried echoing USB3-5, I've tried sudo su and then running it but nothing actually enters a different USB device. I can enable/disable the ones that are already in the list, but I'm unable to add new ones in.
Any ideas?
Cheers!