Full Motion center headrest mount for tablet

peglegtv Offline
Junior Member
Posts: 22
Joined: Aug 2013
Reputation: 0
Post: #1

Here is my tablet headrest mount design, I made it out of wood, PVC and a metal book end so my kids can watch XBMC on long road trips I'm also using the build linked below for the two headrest mounts. next I'll be setting up a power inverter to run 3 outlets in a Kia Sorento so i can do a similar setup as this one here thanks to SKiNNiEH for the idea. 1, outlet for a router 1, for 3TB HDD,1. for laptop charger in the front the other two will be in the rear

This build is simple

Items needed to build it:

2ft - ¾ inch PVC ------------$1.40

3 - ¾ inch 90deg elbows--$.90

1 – ¾ inch Tee----------------$.47

2 – ¾ cap's---------------------$.74

10 – #8 ¾ inch screws-----$1.18

around 13inch – 2x2---------$1.47 (might have to buy an 8ft board)

1 –metal bookend-------------$9.00 a set (shown above in pictures

1 – spray paint ----------------$5.77

5ft - industrial sticky Velcro $15.00 (for 15ft only need the soft side)

total price : $35.93

you'll need to measure the height of your tablet to see what size you need, I'm using a Lenovo IdeaTab A2109 mine was 6 3/8 inches tall so I got the 9inch (7inch would be to short after all the bends)

I found the tablet mount here thanks to RearViewMirror When I made the one for this mount I folded the back piece up instead of doubling it over
(This post was last modified: 2014-09-20 00:35 by peglegtv.)
find quote
Ned Scott Offline
Team-Kodi Wiki Guy
Posts: 21,178
Joined: Jan 2011
Reputation: 276
Location: Arizona, USA
Post: #2

You can make easy links to the XBMC wiki using double brackets around common XBMC words: [[debug log]] = debug log, [[Video library]] = Video library, [[SMB]] = SMB , [[userdata]] = userdata, etc
find quote