2014-04-08, 13:05
I`ve bought some female to female jumper cables and tsop4838 receiver. When i type: dmesg | grep lirc_rpi
I receive the following message back from ssh:
[ 6.728070] lirc_rpi: module is from the staging directory, the quality is unknown, you have been warned.
[ 7.631844] lirc_rpi: auto-detected active low receiver on GPIO pin 18
[ 7.632250] lirc_rpi lirc_rpi.0: lirc_dev: driver lirc_rpi registered at minor = 0
[ 7.632264] lirc_rpi: driver registered!
Then: mode2 -d /dev/lirc0
But I receive the following messages
mode2: could not open /dev/lirc0
mode2: default_init(): Device or resource busy
Im just trying to see if the receiver is working
I`ve then typed irw /var/run/lirc/lircd-lirc0 and ssh doesn't do anything.
Does anyone know where Im going wrong?
EDIT: Tried again, and its working now
I receive the following message back from ssh:
[ 6.728070] lirc_rpi: module is from the staging directory, the quality is unknown, you have been warned.
[ 7.631844] lirc_rpi: auto-detected active low receiver on GPIO pin 18
[ 7.632250] lirc_rpi lirc_rpi.0: lirc_dev: driver lirc_rpi registered at minor = 0
[ 7.632264] lirc_rpi: driver registered!
Then: mode2 -d /dev/lirc0
But I receive the following messages
mode2: could not open /dev/lirc0
mode2: default_init(): Device or resource busy
Im just trying to see if the receiver is working
I`ve then typed irw /var/run/lirc/lircd-lirc0 and ssh doesn't do anything.
Does anyone know where Im going wrong?
EDIT: Tried again, and its working now