2014-04-23, 19:57
Hi there,
I have been using XBMC for a while and am aware that I have never really taken the time to properly set up the audio properly with my home-theater 5.1 amp.
I have my HTPC connected to a Yamaha YHT-294, via HDMI.
http://au.yamaha.com/en/products/audio-v...t-294___l/
I was just wondering whether anyone could confirm the best audio settings to get the most out of my viewing.
So far, I have the following relevant options set:
Under Audio and Subtitle Settings
* Volume - 0.0dB
* Volume amplification - 0.0dB
* Output stereo to all speakers - off
* Audio output - HDMI
Under Audio Output
* Audio output - HDMI
* Speaker Config - 2.0
* Boost volume on downmix - off
* Output stereo to all speakers - off
* Dolby Digital (AC3) capable receiver - off
* DTS capable - off
* AAC capable - off
* Multichannel LPCM capable - off
* True HD capable - off
* DTS HD capable - off
* Audio Output - Direct Sound
* Passthough Output - WASAPI
I am sure that the above is not the best configuration but I am not knowledgeable enough what would be best to use.
Any advice for tweaking would be very much appreciated.
Thanks very much.
I have been using XBMC for a while and am aware that I have never really taken the time to properly set up the audio properly with my home-theater 5.1 amp.
I have my HTPC connected to a Yamaha YHT-294, via HDMI.
http://au.yamaha.com/en/products/audio-v...t-294___l/
I was just wondering whether anyone could confirm the best audio settings to get the most out of my viewing.
So far, I have the following relevant options set:
Under Audio and Subtitle Settings
* Volume - 0.0dB
* Volume amplification - 0.0dB
* Output stereo to all speakers - off
* Audio output - HDMI
Under Audio Output
* Audio output - HDMI
* Speaker Config - 2.0
* Boost volume on downmix - off
* Output stereo to all speakers - off
* Dolby Digital (AC3) capable receiver - off
* DTS capable - off
* AAC capable - off
* Multichannel LPCM capable - off
* True HD capable - off
* DTS HD capable - off
* Audio Output - Direct Sound
* Passthough Output - WASAPI
I am sure that the above is not the best configuration but I am not knowledgeable enough what would be best to use.
Any advice for tweaking would be very much appreciated.
Thanks very much.