ATSC sub channels in EPG
#1
I'm using xbmc as front end for a remote myth 0.27 back end on kubuntu 14.04. Setup is for OTA ATSC. In the channel list, sub channels show up fine (i.e. 33.1, 33.2, 33.3). However, in the EPG, only the man channel (33.1) shows up.

Any ideas?
Reply
#2
You'll need to go into myth, and re-assign channels to get rid of the x.y notation, or turn off "Use backend channel numbers"

Ie, if you have:

7.1
7.2
7.3

You'll need to make them 71, 72, 73 to get all of them.

It's because XBMC uses an integer to represent the channels, and you'll get the first subchannel listed.
Reply
#3
Thanks. Just disabled backend channel numbers.
Reply

Logout Mark Read Team Forum Stats Members Help
ATSC sub channels in EPG0