[Roby77]

Hi, i suggest if it's possibile to have as popcorn hour with the settings in the image below:





With a setup of:

Popcorn hour >Av receiver >TV all over hdmi

I can hear the audio from tv if the av receiver is off (i activated passtrough in standy by in av receiver setup) and i can hear the audio from av receiver if it is on


With xbmc if i don't set enable passthrough and the av receiver is on the audio signal is only in stereo and if i don't disable enable passtrough audio tv doesn't work


(Also with my old receiver connected over spdif audio was streamed simultaneously to tv conntected via hdmi and av receiver, i need only to mute tv audio when av was connected)

thank you

[Roby77]

bump

[Maxoo]

Everything showed on this screen is supported by XBMC. You misconfigured XBMC.
Please set settings level to advanced and take a screen of your audio configuration in XBMC.

[Roby77]

Mmh, some time ago i posted about this problem:

http://forum.xbmc.org/showthread.php?tid=195871

And some one told me that i needed to use json to switch on and off passthrough to automate the procedure


as posted here:

http://forum.xbmc.org/showthread.php?tid=192263&page=2

[Roby77]

Up

[jjd-uk]

XBMC should behave exactly the same as the Popcorn Hour, so I very much doubt the Popcorn Hour was able to passthrough 5.1 to the TV with AVR off unless it was doing something additional to ensure compatibility with both AVR & TV or you've changed something on you AVR that previously allowed this.

[Roby77]

asap i can i will post my settings to find where i make mistake

Thank you

[nickr]

It seems ironic that you want xbmc to behave loke a popcornhour given your .sig message "Never buy a popcorn hour (cloud media) product !!!"

[Roby77]

It's about all the bugs never solved behind a popcorn hour product

[Roby77]

Ok this the screenshot with my settings


screenshot


as i said previously i need to change enable passthrough settings every time

[nickr]

There is a thread somewhere on here about an addon that I think does what you want.

---

http://forum.xbmc.org/showthread.php?pid...pid1749647

[Roby77]

Yes i know and some time ago i tested a variant of the script based on amp switch on and off.

But for example about this image

http://s9.postimg.org/48jnmbzq7/audio_popcorn.jpg

Everything showed on this screen is supported by XBMC. You misconfigured XBMC.
Please set settings level to advanced and take a screen of your audio configuration in XBMC.

Someone speaks as was only a problem of my misconfiguration