2014-06-15, 20:47
I'm trying to select or change channels by entering a 3 digit number on the keypad of my remote. This works fine when I try a channel that starts with a '1'. e.g. 113
However it doesn't work for channels 200 and above. For channels starting with a 1 a little dialog pops up "Switch to channel".
Amy ideas on why this is only partially working?
I don't think it's relevant for this issue but my setup is:
HDHomerun prime
WMCServer
Harmony Ultimate
However it doesn't work for channels 200 and above. For channels starting with a 1 a little dialog pops up "Switch to channel".
Amy ideas on why this is only partially working?
I don't think it's relevant for this issue but my setup is:
HDHomerun prime
WMCServer
Harmony Ultimate