2014-08-11, 05:39
Sorry, this is hard for me to explain, but basically, my EPG works fine, but it only shows the first item in a list of channels. For example, I have a channel that is 10.1, which is my NBC channel. I also have 10.2 which is another channel altogether. However, in the EPG timeline view, it only shows 10.2's info when I view them. (They are in the same group)
I can view 10.1's EPG info when I view it in a group that doesn't contain 10.2. So basically, the EPG can only distinguish the '10' and will only switch to the first 10 in the list. This also applies for a series of channels that start with 61. (i.e 61.1, 61.2, 61.3, etc.) It only shows one of the 61's EPG info and when I select any of the 61 channels in the Channel View list, it will go to the first 61. I could then hit Channel up to go to the others.
Is there are way to make it recognize the decimal values in the channel frequencies or do I need to assign distinct integer numbers to each channel so the PVR can distinguish between them?
Sorry if this doesn't make any sense. I appreciate any advice.
Thanks
I can view 10.1's EPG info when I view it in a group that doesn't contain 10.2. So basically, the EPG can only distinguish the '10' and will only switch to the first 10 in the list. This also applies for a series of channels that start with 61. (i.e 61.1, 61.2, 61.3, etc.) It only shows one of the 61's EPG info and when I select any of the 61 channels in the Channel View list, it will go to the first 61. I could then hit Channel up to go to the others.
Is there are way to make it recognize the decimal values in the channel frequencies or do I need to assign distinct integer numbers to each channel so the PVR can distinguish between them?
Sorry if this doesn't make any sense. I appreciate any advice.
Thanks