2017-03-02, 09:00
I have installed Kodi 15.2 over a clean install of raspbian on RPi2 (I tried OSMC and LibreELEC but neither could pick my wifi so I gave up and went vanilla where wifi works fine). I connected a DIY IR receiver directly to GPIO and configured lirc to extend where it "understands" that the remote is sending something its way (when I stop the lirc server and mode2, it will print some codes when I press buttons on the remote).
This is where I got stuck - I scanned through a lot of documentation on how to get things going, is there a simple description of the next steps I need to take to get going with my setup and Harmony 650 (I guess I could upload any other profile to harmony)? Some instructions refer to enabling the GPIO IR but I don't seem to find any of these options in the kodi system/settings menus.
Appreciate your input. There are multiple instructions on how to get going with these but I am genuinely lost here.
Update:
I have gotten this to work to the point where irw will actually give me something:
How do I now get this activated in Kodi UI?
This is where I got stuck - I scanned through a lot of documentation on how to get things going, is there a simple description of the next steps I need to take to get going with my setup and Harmony 650 (I guess I could upload any other profile to harmony)? Some instructions refer to enabling the GPIO IR but I don't seem to find any of these options in the kodi system/settings menus.
Appreciate your input. There are multiple instructions on how to get going with these but I am genuinely lost here.
Update:
I have gotten this to work to the point where irw will actually give me something:
Code:
pi@raspberrypi:~ $ irw
0000000000000001 00 KEY_UP lirc-irrecord.conf
0000000000000004 00 KEY_LEFT lirc-irrecord.conf
0000000000000004 00 KEY_LEFT lirc-irrecord.conf
0000000000000003 00 KEY_RIGHT lirc-irrecord.conf
0000000000000001 00 KEY_UP lirc-irrecord.conf
0000000000000002 00 KEY_DOWN lirc-irrecord.conf
0000000000000003 00 KEY_RIGHT lirc-irrecord.conf
0000000000000005 00 KEY_OK lirc-irrecord.conf
0000000000000004 00 KEY_LEFT lirc-irrecord.conf
How do I now get this activated in Kodi UI?