2021-03-20, 17:15
(2021-03-20, 17:05)graysky Wrote:@graysky(2021-03-20, 14:13)barracuda Wrote: By the way, i did not reply to your question, when i zoom, i use the slide bar in the options of the movie playing back --> Zoom amount (alongside other options as deinterlace, vertical shift, pixel ratio....)
OK, I can reproduce this when I zoom using the zoom bar. Previously I was just cycling zoom levels via the 'z' key as mentioned.
The artifacts only seem to manifest on 10-bit content when I zoom above 1.00; below is fine.
(2021-03-20, 16:44)popcornmix Wrote: @barracuda use kms not fkms.
For higher specced 4k hevc you need enough cma memory. e.g. use:
dtoverlay=vc4-kms-v3d,cma-512
Arch ARM has been shipping aconfig.txt
based on LibreLE's recommending 512 since they did more or less.
Oh, i have exactly the same issue, only for 10 bits hevc, above 1.00, never below, damn
EDIT : earlier this week, i installed LibreElec 10, and i had exactly the same issue, with Manjaro ARM as well