2009-10-03, 14:33
Hello,
I am setting up a new HTPC and everything was going very smoothly until switching from VGA to HDMI. My TV (a Samsung LCD LE32R74BD) when switched to HDMI is just saying "No Signal".
I am using the Asus AT3N7A-I (Atom & ION board) with 2gb RAM (with 512mb assigned to the GPU in the BIOS). I couldn't see anything in the BIOS for enabling/disabling HDMI.
I installed a minimal Jaunty setup (basic server + ssh).
I then used the XBMscript to install and set up XBMC. I didn't run the script, however, I copied the commands manually as I wanted to make sure I knew what I was doing to my system. But essentially, I performed step 1, installing the stable 185 Nvidia drivers and none of the extra skins.
When switching one of the TTYs I still don't get an HDMI signal.
It is hard to single out of the cause of the problem because:
- I've never used HDMI on this TV before.
- All the hardware is new, and the HDMI cable is new.
Any ideas?
Thanks.
I am setting up a new HTPC and everything was going very smoothly until switching from VGA to HDMI. My TV (a Samsung LCD LE32R74BD) when switched to HDMI is just saying "No Signal".
I am using the Asus AT3N7A-I (Atom & ION board) with 2gb RAM (with 512mb assigned to the GPU in the BIOS). I couldn't see anything in the BIOS for enabling/disabling HDMI.
I installed a minimal Jaunty setup (basic server + ssh).
I then used the XBMscript to install and set up XBMC. I didn't run the script, however, I copied the commands manually as I wanted to make sure I knew what I was doing to my system. But essentially, I performed step 1, installing the stable 185 Nvidia drivers and none of the extra skins.
When switching one of the TTYs I still don't get an HDMI signal.
It is hard to single out of the cause of the problem because:
- I've never used HDMI on this TV before.
- All the hardware is new, and the HDMI cable is new.
Any ideas?
Thanks.