Posts: 55
Joined: Apr 2010
Reputation:
0
Thanks,
the link was very helpful. I used the ssh command to add repo to launcher. It installed OK, but since my card has not arrived yet, I remains to be seen.
How to install latest XBMC from snv? Can I use launcher as well? Is there a recommended build for crystal HD, or just the latest? Trac says it is 3 weeks to final release. Do you think it is better to wait or just install now from svn?
Posts: 55
Joined: Apr 2010
Reputation:
0
Hi Guys,
Is it true that the projects around XBMC were canceled or delayed? There is a lot of activity going on from December till the end of February and then suddenly no binary builds any more. Same with Crystal HD drivers and support. Is there going to be a completely stable version any time soon?
Posts: 55
Joined: Apr 2010
Reputation:
0
I finally got the crystal HD card yesterday. It works fine with the svn build of XBMC. But another issue appeared - networking problem. I am watching all movies (including HD) from a NAS drive. The connection is like that:
Apple TV > 100 Mbit/s cable > Dlink 1522 Wireless-n bridge > Dlink DIR-655 Wireless-n router > 1Gbit/s cable > Synology NAS
I am getting buffering messages a lot when watching HD movies. My router shows that connection between itself and the wireless bridge is 108 Mbit/s most of time, but sometimes drops to 54 Mbit/s. Signal strength is around 60-70%. Buffering (movie playback stopped) happens also when the router shows 108 Mbit/s connection speed.
Does anyone has a solution to this? I spent $150 on getting the crystal HD card and I still cannot watch HD movies without multiple buffering incidents spoiling the joy.
Could you guys implement some workaround in XBMC? Like a bigger buffer for files opened from network drives?
Posts: 392
Joined: Apr 2009
Reputation:
1
Most likely not. So if you have the chance to test it without wireless connection and it works, you could try if the tweak works when you revert back to wireless,
Vero 4k+ | OSMC Kodi 19.1
Sony KD-65A1
Posts: 608
Joined: Dec 2008
Reputation:
0
reddeath,
Wireless is a bit "iffy" to say the least. The speed your router claims isn't really anything more than some calculations done on the signal strength and noise levels. Your setup is using the 2.4ghz band which is the same frequencies as 802.11B/G. That band has 3 independent channels. That means you'll have a lot of interference from other networks around you.
Make sure your router is setup to use WPA2 and AES encryption. Also make sure it's set at 40mhz band width. That's the only way you can get proper N speeds on most routers (D-link included).
I used 2.4ghz N for a while and could stream one 1080p video across it. Now I'm running both 2.4 and 5ghz bands and can keep up with any demand I've tried. Multiple 1080p streams while streaming HD from the net works without issue now.