2010-01-22, 03:37
Hello all.
I got my Crystal HD the other day and installed it and had it up and running for a few hours. After a while the video playback became choppy, so I restarted and came back to it tonight to see what was up. I updated r27056 and now I can't get the HD recognized at all.
dmesg shows this during boot:
Then when I load XBMC I see this:
This seems like a new error to me. Any ideas?
Thanks
I got my Crystal HD the other day and installed it and had it up and running for a few hours. After a while the video playback became choppy, so I restarted and came back to it tonight to see what was up. I updated r27056 and now I can't get the HD recognized at all.
dmesg shows this during boot:
Code:
BroadcomCrystalHD::start
allocated 18 elem
Starting BCM70012 Device
clock is moving to 175 with n 35 with vco_mg 2
CStopping BCM70012 Device
BroadcomCrystalHD: Found HW and started driver SW.
Then when I load XBMC I see this:
Code:
Starting BCM70012 Device
clock is moving to 175 with n 35 with vco_mg 2
CInitializing Dio pool 10 1024 3058 0x1dbbf24
Firmware Downloaded Successfully
*ERR*:/Users/davilla/Documents/crystalhd-for-osx/trunk/crystalhd/driver/darwin/crystalhd_hw.c:1799: Firmware command T/O
*ERR*:/Users/davilla/Documents/crystalhd-for-osx/trunk/crystalhd/driver/darwin/crystalhd_hw.c:1810: FwCmd Failed.
fw cmd 73763001 failed
Closing user[0] handle
Deleting IOQs
Releasing RX Pkt pool
Released dio pool 10
Stopping BCM70012 Device
This seems like a new error to me. Any ideas?
Thanks