2011-02-27, 09:32
Hello all.
I'm having alot of trouble getting the axis' to keymap.
I'm running a custom driver compared to the windows one (Much better than microsofts) http://www.katch.ne.jp/~morii/driver/x360wc/index.html
Reason i went with this custom one was because:
-You can assign a button to the middle one.
-You dont need to turn on the controller before xbmc
-all buttons are re-mappable
All the buttons will map fine excluding the left thumb and right thumb.
I've played around with it for about 4 hours but only managed to get two directions to work.
Could anyone please help me do this?
I've tried pretty much all axis ID's upto 6 and doing -1, 0, 1, +1 for the axis point.
I'm unsure if it's my keymapping.xml that's at fault here or the driver isn't setup correctly.
Any helps would be muchly appreciated.
I'm having alot of trouble getting the axis' to keymap.
I'm running a custom driver compared to the windows one (Much better than microsofts) http://www.katch.ne.jp/~morii/driver/x360wc/index.html
Reason i went with this custom one was because:
-You can assign a button to the middle one.
-You dont need to turn on the controller before xbmc
-all buttons are re-mappable
All the buttons will map fine excluding the left thumb and right thumb.
I've played around with it for about 4 hours but only managed to get two directions to work.
Could anyone please help me do this?
I've tried pretty much all axis ID's upto 6 and doing -1, 0, 1, +1 for the axis point.
I'm unsure if it's my keymapping.xml that's at fault here or the driver isn't setup correctly.
Any helps would be muchly appreciated.