[Live][Wicd] Wicd doesn't recognize any networks
#1
Hello there,

I installed XBMC 10.0 on a external Hard drive and then followed those instructions:

http://forum.xbmc.org/showthread.php?tid=90410

It worked like a charm and I was happy.

Then my hard drive broke, and I had to get a replacement.

I reinstalled everything the exact same way I did at first, but I couldn't get the network working.

If I install the AddOn and then install Wicd in the AddOn, it shows no networks after scanning.

If I enter the console, and enter the Wicd-curses, I get the usual window.
In this window no key works except Help, Config and Quit. I can't select preferences or refresh. My network (which used to work) doesn't show up.

I checked this for 2 different systems, same results.

Here the information for the system where it used to work:


Code:
iwlist scan:

lo Interface doesn't support scanning.

eth1  Interface doesn't support scanning.

wlan0 Failed to read scan data : Network is down

Code:
IFCONFIG WLAN0 UP

SCIOCSIFFLAGS: Permission denied

Code:
IWCONFIG

lo no wireless extensions

eth1 no wireless extensions

wlan0 IEEE 802.11bgn  ESSID:off/any
    Mode: Managed Access Point: Not-Associated Tx-Power=0 dBm
    Retry long limit:7 RTS thr:off Fragment thr:off

Any ideas what happend? And how I can get it running again?

Thanks a lot in advance,
Cheers
Reply

Logout Mark Read Team Forum Stats Members Help
[Live][Wicd] Wicd doesn't recognize any networks0