[AppleTV] Fresh Install and No Audio in Dharma? - Printable Version +- Kodi Community Forum (https://forum.kodi.tv) +-- Forum: Support (https://forum.kodi.tv/forumdisplay.php?fid=33) +--- Forum: General Support (https://forum.kodi.tv/forumdisplay.php?fid=111) +---- Forum: Mac OS X (https://forum.kodi.tv/forumdisplay.php?fid=56) +---- Thread: [AppleTV] Fresh Install and No Audio in Dharma? (/showthread.php?tid=91659) |
[AppleTV] Fresh Install and No Audio in Dharma? - klaus1013-2 - 2011-01-22 I recently upgraded from 9.x to Dharma on my AppleTV and lost audio in almost all my films. I did some troubleshooting and a lot of searching on this forum, but could not find a resolution. I have now upgraded the OS on the AppleTV from 2.3 to 3.0.2 and the Launcher version is 3.2.5. I re-downloaded XBMC 10.0 and removed all my saved settings and unfortunately I'm stuck with the same problem. If I leave the audio settings to default the audio crashes when I play a file, once back in XBMC there is no navigation audio. Setting up the audio settings properly and I still get no audio in films, but I still get navigation audio after exiting a film. Audio settings are: Audio Output: Optical/Coax Speaker Config: 5.1 Boot volume on downmix: Yes Dolby Dig Capable: Yes DTS capable: Yes Audio Output device: Tried both default and Built-in Line Output I'm using optical and my receiver is a Sony STR-KS1000. I've tried various files, but the file I keep going back to for testing has the following mediainfo: AVI: 700MiB, 1h 00mn Writing Application: Nandub v1.0rc2 Writing Library: Nandub build 1852/release 1 video stream: MPEG-4 Visual (XviD) 1 audio stream: AC-3 (448Kbps, 48KHz, 16 bits, 6 channels) This file works fine in Boxee. My xbmc.log is available at: http://pastebin.com/VwPvq4i0 I think I've covered everything, but please lmk if I can provide any more info. Thanks, Nick - klaus1013 - 2011-01-23 Any ideas on this anyone? Sorry to bump my own post, but I've been using XBMP/C for four years and atm it's unusable Thanks, Nick - hacunha - 2011-01-26 I still did not find an answer a smilar problem. http://forum.xbmc.org/showthread.php?tid=91621 Anyone, please help. |