2014-06-24, 12:22
(2014-06-24, 02:31)DocG Wrote:(2014-06-23, 13:38)marck120 Wrote: The article that I had shown was this: http://blog.tynemouthsoftware.co.uk/2012...ified.html, I had not realized it was a project carried out by you, in this photo but you write that you have soldered the cable to the device: http://www.imagebam.com/image/f16a9e334730441
The audio cables from the CD-ROM are still in business ?
I forgot to ask you something, what about you which remote you use ?
The case antec isk 110 I have chosen is very small, I have to find a way to place the CIR receiver so that it takes the signal from the remote control, do you have any solution to this ?
Not my project, I simply copied the wiring. I did not need to solder anything, nor would I solder anything to my motherboard.
I had plenty of spare old audio cables, but you can use just about any cable with appropriate connectors.
I'm using an old standard MCE remote. Any standard MCE remote should do.
At the front, where there's a little hole in the case, or a mesh. Also depends on what CIR receiver you're going to chose. If you just wire up a TSOP4838 to your CIR header, that thing is small, it fits just about anywhere.
Thank you, ok now I understand. Regarding the IR receiver I was going to use this : http://www.conrad.it/ce/it/product/18181...ad-IR-R-36 , Costs 5 euro, if I take the model should I buy TSOP4838 cable too, unfortunately I do not have spare cables to be used, I checked in the various shop but I could not find the cable with the connector at suitable. I do not necessarily need to use an audio cable to CD-ROM ?