2012-04-29, 23:25
Alright, decided to start putting this thing together. Ended up picking up a Shuriken Rev B SCSK-1100, for $29.99 I figured I might as well vs building it with the stock fan and potentially finding it too loud. Still don't have my RAM, but have a stick of 1GB DDR3 I can use if I have to to hold me over.
This is the first PC I've build entirely from scratch, and the first thing I'm noticing is holy cow there are a lot of cables on this build! I removed the fan to gain more access.
I've connected..
1. 24 pin power
2. USB cable to one of the two available USB connections (USB89 instead of USB67 - does this matter??) on the Mobo
- In between these two USB connections is a CIR connector, which I assume I don't use unless I purchase the Asrock remote??
3. The mobo came with a couple SATA3 cables, so I connected one to SATA3-1 for my SSD.
4. The HD Audio cable from the case to the mobo. Question, there was also an AC'97 cable connected to the HD Audio cable, but I don't see anywhere to connect this, so I assume if one doesn't have HD Audio one would connect the AC'97 instead?
5. There was another SATA cable attached to the case where the USB/Audio and other front connections are, so I attached this to SATA3?
6. Connected the Shuriken Fan to the CPU Fan 1 connector on the Mobo.
7. Connected the PowerLED +/- cable from the case to the Mobo
8. Connected the Reset SW to the Reset# and Ground Pins (I'm assuming the black wire IS NOT the ground?)
9. Connected the Power SW cable to the PWRBTN# and Ground (again, assuming the black wire IS NOT the ground here?)
Still have a whack of cables left, but no idea whether to connect any of them?
Thanks!
Oh, and the cable management is BRUTAL right now. Ugly.
This is the first PC I've build entirely from scratch, and the first thing I'm noticing is holy cow there are a lot of cables on this build! I removed the fan to gain more access.
I've connected..
1. 24 pin power
2. USB cable to one of the two available USB connections (USB89 instead of USB67 - does this matter??) on the Mobo
- In between these two USB connections is a CIR connector, which I assume I don't use unless I purchase the Asrock remote??
3. The mobo came with a couple SATA3 cables, so I connected one to SATA3-1 for my SSD.
4. The HD Audio cable from the case to the mobo. Question, there was also an AC'97 cable connected to the HD Audio cable, but I don't see anywhere to connect this, so I assume if one doesn't have HD Audio one would connect the AC'97 instead?
5. There was another SATA cable attached to the case where the USB/Audio and other front connections are, so I attached this to SATA3?
6. Connected the Shuriken Fan to the CPU Fan 1 connector on the Mobo.
7. Connected the PowerLED +/- cable from the case to the Mobo
8. Connected the Reset SW to the Reset# and Ground Pins (I'm assuming the black wire IS NOT the ground?)
9. Connected the Power SW cable to the PWRBTN# and Ground (again, assuming the black wire IS NOT the ground here?)
Still have a whack of cables left, but no idea whether to connect any of them?
Thanks!
Oh, and the cable management is BRUTAL right now. Ugly.