2013-01-09, 21:23
I have recently got my raspberry pi got it all set up etc. I followed a guide and set up the config file etc also i have overclocked the cpu to modest settings
arm_freq = 850
core_freq = 325
sdram = 425
over_voltage = 2
And i seem to be getting a few crash problems. Has anyone experienced this before with them settings?? Or does anyone know of decent settings i should use in config??
Also i did not change turbo_charge.
One last thing is i changed the below and noticed its still quite small on screen when using gui
Please check settings and see if ok
# Make display smaller to stop text spilling off the screen
overscan_scale=1 # http://www.raspberrypi.org/phpBB3/viewto...67&t=15700
disable_overscan=1
overscan_left=57
overscan_right=59
overscan_top=20
overscan_bottom=20
In fact it would be a lot easier if i post my config.txt file http://pastebin.com/7Bcj6md8
please have a look and see if i can make changes to stop crashes. Thanks guys
arm_freq = 850
core_freq = 325
sdram = 425
over_voltage = 2
And i seem to be getting a few crash problems. Has anyone experienced this before with them settings?? Or does anyone know of decent settings i should use in config??
Also i did not change turbo_charge.
One last thing is i changed the below and noticed its still quite small on screen when using gui
Please check settings and see if ok
# Make display smaller to stop text spilling off the screen
overscan_scale=1 # http://www.raspberrypi.org/phpBB3/viewto...67&t=15700
disable_overscan=1
overscan_left=57
overscan_right=59
overscan_top=20
overscan_bottom=20
In fact it would be a lot easier if i post my config.txt file http://pastebin.com/7Bcj6md8
please have a look and see if i can make changes to stop crashes. Thanks guys